Nov 042020
 

Das ist mal eine große News die Bigtree da heute raus gehauen hat, denn am 11.11.2020 wird das neue SKR E3 Turbo released und darauf freue ich mich wahnsinnig, denn aktuell habe ich im drei Druckern die ich hauptsächlich nutze das E3 Mini V2 drinne und werde diese nun nach und nach upgraden, denn das neue E3 Turbo kommt mit dem selben Prozessor wie beim SKR 1.4 Turbo und das heißt, dass die Prozesse noch schneller werden.

Die größte Neuheit ist dabei wohl der Wechsel auf den LPC Prozessor und auch sind wieder 12-24V möglich. Zudem bekommt der USB-Port eine neuen USBLC6-2 Schutz mit dem dieser vor Beschädigungen geschützt wird. Wie gehabt sind auch die beliebten TMC2209 Treiber an Board, welche flüsterleise ihren Dienst tätigen.

Interessant ist die Neuheit das dieses Board einen eingebauten NTC100K Thermistor hat mit dem in Echtzeit die Temperatur vom Mainboard abgelesen werden kann und das ist eine wichtige Funktion, denn so kann man sehen, inwiefern das Board belastet wird und auch, ob die vorhandene Kühlung ausreicht.

Es gibt aber auch noch ein paar weitere Neuigkeiten die Ihr wie immer weiter unten lesen könnt. Das neue SKR E3 Turbo ist auch schon in der Marlin Config vorhanden, so dass ein Wechsel ohne Probleme funktionieren sollte.

🎉The SKR E3 Turbo adopts SGM6130 power chip, and it supports 12-24V power input. The power conversion rate is up to 94%, and the maximum output current can reach 2.5A.
🎉Add the protection device to the thermistor interface.
🎉The USB port adopts the ESD protector USBLC6-2, which effectively protects the USB port from damage.
🎉The main control adopts LPC1769 chip. (up to 120MHz frequency and the ARM of Cortex-M3)
🎉5 TMC2209 drivers on board, supporting dual extruders.
🎉Onboard NTC100K thermistor, real-time monitoring of motherboard temperature.
🎉The Standby function of TMC2209 is added. You can change the firmware and set the function according to your needs. (In this mode, the driver chip will automatically cut off the power supply to the motor, and its own power consumption will be minimized, thereby effectively reducing power consumption.)
🎉The heating rod interface adopts pluggable wiring terminals, which makes your wiring process more convenient and quicker.
🎉Add I2C main circuit expansion interface and UART expansion interface for DIY.

  One Response to “BTT SKR E3 Turbo kommt am 11.11.2020”

  1. […] BTT SKR E3 Turbo kommt am 11.11.2020 […]

Kommentar verfassen