EZ BMG Extruder mod for Artillery Sidewinder X1

Website
https://www.thingiverse.com/thing:3916870
Resolution:
20
Infill:
20
Thingiverse Copyright
sprocketscientist

This is a very simple adapter to attach a BMG extruder to the Sidewinder X1 with minimal new mounting hardware needed. Other than a BMG (Bondtech or clone), the only hardware needed is three M3 nuts. Uses the original hot end and heatsink.

Remove the original PTFE tube from the stock hot end. Slide a new piece down in until it hits the nozzle, then cut it 54mm above the top of the cold block.

Print the mount on the cut off corner so it is all at a 45 degree angle, and you won't need support.


Slide the mount down over the new PTFE tube and snap it into place on the heat sink mounting hole stud (the hole where the previous large extruder gear was mounted). Snap the other side of the original extruder on. Run the mounting screws through as if they were going into the extruder motor, but instead fasten with M3 nuts.


Assemble the BMG extruder on top of the mount's V6 style post. Install the original motor with the wiring connections facing downward. This allows the original short cable to connect to the extruder board.


Attached the extruder board and make all the electrical connections. Set your steps per mm to 415 and test it out.

Bilder

  • Version

3DFilaPrint
ANZEIGE
s3dproducts
ANZEIGE
3D Printerstore CH
ANZEIGE